If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hold down start and 6 while turning on the machine the press 2 and start this will bring you to the maintenance list and it will help you locate what needs to be replaced or you can also clear the counters in this same mode.
both methods are right.... but techman is very right... do you PM's ..... these machines need there PM's done promptly and use the kits... dont scrimp on a few bux because you think it will be ok without that small part you think wont matter... i used to have 150 of these to work on ... if you do the pm's and use the kits ... and USE 281C colour dev .... they arent that bad
Comment