Have a 6505 ac e010 won't clear. Fuser transport sensor checks fine, changed it anyway. According to the manual, ADU pcb is bad. Changed that, PFC pcb, logic pcb, ADU interface cable and even the fuser. No luck. Machine has 179k on it. Out of ideas.
-
-
Re: 6506AC E010
If it's a new sensor with good connections, but does not pass the sensor check (Perform the input check: FS-03-[ALL]OFF/[2]/[C], FS-03-[F1]ON/[5]/[F]), then I'd change the ADU PWB. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
Re: 6506AC E010
Does the machine sense when the duplex door is opened/closed and the bridge unit?Defects are simple, our mind is complicatedComment
Comment