Altalink C8170 Enter Current Password Message is Displayd at Start Up !!!

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • xcopytech
    replied
    Re: Altalink C8170 Enter Current Password Message is Displayd at Start Up !!!

    Did you try special altboot
    Do you know what is special altboot

    Leave a comment:


  • kropa
    replied
    Re: Altalink C8170 Enter Current Password Message is Displayd at Start Up !!!

    I have a new HDD for this car. but the machine has stopped flashing and always asks for a password. I tried to put . maybe the main board will die?

    Leave a comment:


  • xcopytech
    replied
    Re: Altalink C8170 Enter Current Password Message is Displayd at Start Up !!!

    Check or replace hdd and then perform special altboot
    Download files for special altboot

    Leave a comment:


  • kropa
    replied
    Re: Altalink C8170 Enter Current Password Message is Displayd at Start Up !!!

    There is a similar, exactly the same working machine. If I knew for sure that I could try to throw it from the working one so as not to break it, I would have thrown it.

    Leave a comment:


  • kropa
    replied
    Re: Altalink C8170 Enter Current Password Message is Displayd at Start Up !!!

    I created a folder as in the service manual, inside put the firmware file and two more files without extension

    DISABLE_DATA_BACKUP
    FORCED_UPGRADE
    XeroxAltalink_C8170_ALTBOOT_system-sw#11401101128800#ENG_MOD.DLM

    Leave a comment:


  • kropa
    replied
    Re: Altalink C8170 Enter Current Password Message is Displayd at Start Up !!!

    the machine went through all the stages, rebooted several times and said remove the usb flash drive

    Leave a comment:


  • kropa
    replied
    Re: Altalink C8170 Enter Current Password Message is Displayd at Start Up !!!

    Originally posted by Gaffers01
    Нужно сделать "Special Altboot"
    XeroxAltalink_C8170_ALTBOOT_system-sw#11401101128800#ENG_MOD.DLM
    I downloaded this album, I think this is what you are writing about?
    Only this one was accepted by the machine.

    Leave a comment:


  • Gaffers01
    replied
    Re: Altalink C8170 Enter Current Password Message is Displayd at Start Up !!!

    Need to do "Special Altboot"

    Leave a comment:


  • kropa
    replied
    Re: Altalink C8170 Enter Current Password Message is Displayd at Start Up !!!

    Originally posted by Gaffers01
    Можете ли вы прикрепить фото побольше?
    in the photo it looks like entering the PC BIOS. and just see the current password. very small window in the middle.

    Leave a comment:


  • Gaffers01
    replied
    Re: Altalink C8170 Enter Current Password Message is Displayd at Start Up !!!

    Can you attach a photo that is bigger ?

    Leave a comment:


  • Altalink C8170 Enter Current Password Message is Displayd at Start Up !!!

    Устройство циклически перезагружается (по индикатору -У)

    после того, как требуемая прошивка запрашивает сразу ввод пароля, как на фото, при нажатии на кнопку питания перезагружается и снова запрашивает ввод пароля (дает 3 процедуры).
    Принудительно прошить еще раз не получилось, вставил новый жесткий диск.

    на индикаторе -6

    подключил внешнюю usb-клавиатуру и ввёл пароль 6789 1111 условие для установки лицензии.

    помогите кто с таким столкнулся, меня скоро убьют..... СПАСИБО!!!!!
    Attached Files
    Last edited by kropa; 01-18-2024, 04:57 PM.
Working...