Module Xerographic WorkCentre Pro65

[adriansto]

Re: Module Xerographic WorkCentre Pro65

You CAN NOT use any 24Cxx chip with WCPro65. The machine NOT ACCEPT to talk with 24Cxx chip
The WCPro65 accept only original xerox01 - xerox90 chip.

[Enzo]

Re: Module Xerographic WorkCentre Pro65

You CAN NOT use any 24Cxx chip with WCPro65. The machine NOT ACCEPT to talk with 24Cxx chip
The WCPro65 accept only original xerox01 - xerox90 chip.

So I can only find a program that writes the original eprom xerox01 - xerox90! Damn!

[Enzo]

Re: Module Xerographic WorkCentre Pro65

Nothing programmer is able to reset the chip wcp65! It has the code: XC01 S/54SR. The sites indicate how bad chip!

[Enzo]

Re: Module Xerographic WorkCentre Pro65

I am able to write data on a chip. Now I have the data in a chip wcp65 already arrived to 60,000 copies. I can change (by particular software) the value of 60,000 and bring it back to 0?

[KHALEDGAD77]

Re: Module Xerographic WorkCentre Pro65

I am able to write data on a chip. Now I have the data in a chip wcp65 already arrived to 60,000 copies. I can change (by particular software) the value of 60,000 and bring it back to 0?

can u send me this program what akind of the epprom

[KHALEDGAD77]

Re: Module Xerographic WorkCentre Pro65

can u send me this program what akind of the epprom

khaledgad77@yahoo.com

[Enzo]

Re: Module Xerographic WorkCentre Pro65

Hello friends. recently my WCP65 gives me this defect. (see attached)
The Xerographic module is new, even the fuser is new. I noticed that the sheet gets dirty when it comes to the developer. but I clean it. What can it be?

scan wcp65.pdf

[Enzo]

Re: Module Xerographic WorkCentre Pro65

clean the doner roll in developer housing.
clean ros.
make a xerografics setup.

I've already done! I also put a new laser!

[Enzo]

Re: Module Xerographic WorkCentre Pro65

Them You have a BAD xerografics module.

but I have 3 new xerographic modules and all of them have the same problem. is not possible!

[Enzo]

Re: Module Xerographic WorkCentre Pro65

Unfortunately I have no other machines to test my modules. I have 4 new modules and they all do the same problem. I will try to better clean the developer.

[Enzo]

Re: Module Xerographic WorkCentre Pro65

I opened it and clean the developer but the problem remains!

[Enzo]

Re: Module Xerographic WorkCentre Pro65

hello friends. some technicians have told me that my problem to eliminate the copy shaded, need connect with PWS and run diagnostic. I have some programs and now the car showed me the message of "diagnostic starts." but I can not make it work. maybe I'm missing some program or not I can. can you tell me exactly what program is necessary and how it works? I have already managed to reload the software on the DC440st, I think that with your help I'll be able to do this for the wcp.
thanks