[Jamming] IRAC5535i Broken Loop Sensor Arm FC8-5303-000

[copier tech]

Hi all,

Quick question, what's the easiest / quickest way to access & replace this actuator please? It's not covered in the service manual.

FC8-5303-000.jpg

[GIUBOSS]

Re: IRAC5535i Broken Loop Sensor Arm FC8-5303-000

Heat a metal paperweight with a gas lighter and push it into the severed part of the sensor, then cut it to 15mm with a wire cutter (for those with patience and a steady hand), good luck.

[copier tech]

Re: IRAC5535i Broken Loop Sensor Arm FC8-5303-000

Heat a metal paperweight with a gas lighter and push it into the severed part of the sensor, then cut it to 15mm with a wire cutter (for those with patience and a steady hand), good luck.

Unfortunately the school threw the broken bit away!

Just wondered what you best way is to access it (new one on order)

[GIUBOSS]

Re: IRAC5535i Broken Loop Sensor Arm FC8-5303-000

You don't need the piece of the sensor that was lost, I didn't doubt it, but you would have built the sensor yourself

[bobburnsreb]

Re: IRAC5535i Broken Loop Sensor Arm FC8-5303-000



Push down where you see my thumb and it will separate.

[copier tech]

Re: IRAC5535i Broken Loop Sensor Arm FC8-5303-000

Push down where you see my thumb and it will separate.