32 results in 0.0181 seconds.
-
SR5000/5020 (B083) SC745 Error Feed-Out Belt Motor Error
This likely applies to other model numbers of this finisher as well. After a changed staple cartridge SC 745 showed. Found the bracket that holds the... -
press c12000
Hello group, has anyone had any problems with the transfer belt module? The image is distorted when transferring to paper... I have already ruled out... -
patterson70 started a topic Xerox 7855 jams out of drawer 2 but not three. New rolloers in all drawers.in XeroxXerox 7855 jams out of drawer 2 but not three. New rolloers in all drawers.
Hello, I am getting jams out of drawer 2 with letter long edge first but not the high capacity drawer 3, which can only be long edge first. I did not... -
TASKalfa 306ci cleaning blede
Please , have you tip for some alternative drum cleaning blades ??
I have many costomers with TA 306ci with low total counter and after 4 years... -
Konica C654e finisher not detected
Customer called with a jamming issue-----turns out the FS-534 finisher is not detected so the paper reaches the RU-513 horizontal transport unit and wads... -
BH c203 with fs519 folding and jamming at finisher exit
I am wondering if anyone has seen this before it seems to fold the leading edge before it turns over to exit. one of the mylar guides near the front of... -
C6000L tray 2 lift
Morning Folks,
Hope your all good.
Something that has been baffling my brain. We have an issue with tray 2 not lifting. Everything... -
Bent corners on Bizhub 20 solution
Bent corners, happened between drum and fuser. I knew this because the whole image was present on the paper, even under the bent corner.
Turned... -
MPc6000 Stripper Fingers
Hi,
Has anybody had problems with the stripper fingers (the plates, that it) being bent on the MPc6000 type machines? We've got a problem... -
-
ir 5055 bent print
Enlarge to beter wiew.Probably something about laser.Any sugestions?Thanks.
... -
fold skew Doc 240
About a quarter inch skew top to bottom on an 8.5x11 booklet folded to 5.5x8.5. Standard uncoated paper, fold and staple function. 4 sheets. Is there... -
2238C Constant SC-388 SC-389
This machine had been unlevel because the floor is sagging(higher in back than front) so at first I figured it threw off the toner sensors or something.... -
KM-6030 J13
Unit has only about 330k. Checked the rollers, replaced sep roller installed red spring with no difference. I can hear the motor attempting to feed with...
