Has anyone run into this code yet C-FD8B ? Says a pinched wire. This is a brand new unit.
Thanks for any input!
K
8 results in 0.0212 seconds.
-
E733-001
I got this after I removed the main controller and the DC controller to replace the waste toner drive assby.When I replaced everything in order I get... -
cs 5035
we have a cs5035 w/srdf2, the lift up plate is stuck in the up position. is this a board problem or the solenoid/ the solenoid seems to be constantly... -
Minolta 250 Problem
Hi
I have been recently working on a minolta 250 which has a problem it will scan the paper that needs to be copied but will not go onto... -
Need help on Konica 7145
Loop clutch not activating (no 24v volt to loop clutch) . I tested all other components using mode 47 and they were fine. Replaced print control board,HVDC1,loop... -
Mita DC-5686
I have a machine that ejects the originals out of the document feeder about 5 times faster then normal. I tried the RADF main board and that didn\'t work.... -
Imagistics IM2520/Konica MinoltaDI 2510
Have not seen problem in person, another tech called me and asked to post. Display has lines 1/16\" wide running horizonal and vertical. You... -
code 621 mita 8090
getting code 621 main pcb has been replaced and checked for pinched or disconnected wires i am able to reset this code and make copies but it takes alot...
