[Error Code] iR 6800 Error E000061-0008

[samsogoye]

Hello,
I need your help on this printer when I turn it on it start waming up when it start initializing the whole system it stuck and pring this error message.
Sam From Tanzania E.Africa

[SCREWTAPE]

Try a component called the primary corona.

Are you a tech?

Screwtape from the United States of America.

[samsogoye]

Yes Iam a Tech, I have try primary Corona its ok because when I turn on printer its start rotate,

[teckat]

****************Replace the primary corona assembly

will rotate until potential control is measured =then Error 061-0008 > dark area Pot.Adj too low

[samsogoye]

****************Replace the primary corona assembly

will rotate until potential control is measured =then Error 061-0008 > dark area Pot.Adj too low

Thanks o much for your contribution , So the The primary corona assembly should be changed what about dark area pot.adj too low what am I suppose to do?

[Paul 75]

If you change the Primary this will sort. Also check your wiring into he machine frame connector block for the pot control. These are pulled in and out frequently so all connectors involved with pulling the process assy out are a issue. Check also discharge lamp connector above the cleaner blade and make sure there clean. Is the blade cleaning ok?. If you turn off Pot Control what sort of copy do you get?. Sometimes turning P/C off then on rectifies problems. Good luck!!

[teckat]

Thanks o much for your contribution , So the The primary corona assembly should be changed what about dark area pot.adj too low what am I suppose to do?

either Primary unit is Bad or Drum surface is poor / simple deduction

[SCREWTAPE]

Just replace the corona.

[samsogoye]

If you change the Primary this will sort. Also check your wiring into he machine frame connector block for the pot control. These are pulled in and out frequently so all connectors involved with pulling the process assy out are a issue. Check also discharge lamp connector above the cleaner blade and make sure there clean. Is the blade cleaning ok?. If you turn off Pot Control what sort of copy do you get?. Sometimes turning P/C off then on rectifies problems. Good luck!!

When it finish warming up it start rotating the whole system after 2 to 3 seconds it stuck and bring the error message, by that way it cannot print .

[samsogoye]

either Primary unit is Bad or Drum surface is poor / simple deduction

Thanks let me start this mission because here in Tanzania its imposible to find those iquipment..thanks thanks

[samsogoye]

Just replace the corona.

Screw thanks let me find the corona

[Herrmann]

First at all, make sure, that the atr and the patch sensor is clean

[samsogoye]

okey Herman

[teckat]

First at all, make sure, that the atr and the patch sensor is clean

good point, but machine goes in Error 2/3 seconds after turn on /too soon to involve patch sensor

[samsogoye]

Not after 2/3 sec after turn on. When I turn on machine start to warm up when finish it start to enter into gradation process when it is in that process it start to rotate the whole mechanism I think its 3, 4 seconds then it stuck

SORRY FOR MY ENGLISH I AM TANZANIA from E.Afrika