c6500 drum blade flipping

[random]

Anyone have this? Have a fix?

[dogsbody]

had it the other day, i fixed it by putting a 2nd hand drum in it. the new drum was in for less than half a day. PTSC say that the techs in Sydney are "adjusting" (stretching) the springs that put the pressure on the blade. I don't know how successful they have been.
would like to say i have a fix because i have been putting off fitting another new drum while the 2nd hand one works - don't know if i am just going to end up with more of the same.
Cheers.

[Albonline]

this problem was ecalated to japan. temp workaround . enter sev mode, select 2, select 5, select 2. set auto refresh to small. also load drum with setting powder roll drum till clean reload with setting powder.

[Scott_Lewis]

Anyone have this? Have a fix?

Yes, only one in territory. Flipped about 5 blades so far. No.

Waiting for KM to come out with a CB that is has more meat and just a bit longer (in the short dimension) to cut down on the incidence angle to the drum.

[Haroldbfix]

Konica releases a firmware fix for this 30GCA, however I dont know how well it works. I have installed this firmware on a notorious c6500 for this issue. I think they called back one more time after that for blade flip. I havent heard anything else about it since then. Its been a couple of months.

Check the database, there are alsosome dipswitches to set, I recommend maxing out those settings.

[redime]

Solution... stop using Katun blades

[random]

perhaps I should start using Katun blades as all our stuff is original konica

[redime]

perhaps I should start using Katun blades as all our stuff is original konica

Clearly you missed the joke...

[random]

right over my head mate

[trapps]

trapps

Some success with stretching the original (gold) c6500 springs or fitting c500 springs(better bet).Know of one that flipped with c500 springs. I swopped c500 blade and springs and fitted it to c6500 drum, great success. Have a go.

[bowser]

random instead of using just the springs from the c500/8050 use the springs from old drum and order the c500 cleaning bladeas well you will see the blade is much longer and will glide better.
this also solves the toner build up on the drums (a little more mony ess problems).

[bowser]

this works have done ti many times now(a little more mony ess problems).

hear this problem is solved on the 6501

[laserman06]

Just heard today from KM rep. I posted what I found out on the thread listed below


See this thread http://www.copytechnet.com/forums/ko...lade-drum.html

[AQBJ8]

Anyone have this? Have a fix?

Change a new one!the blade so bad!

请换新的刀片 换了之后再加安装粉

也许是那刀片太差了

￥ぇォΘ

[VIJN]

re c6500 drum blade flip, i have fitted the application roller and pads from a 8050 drum unit to my c6500 drum units have gone from flips every 8k to life of over 200k on my last 16 drum units.