Fitting a C454e fuser to a C224e model

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • copier tech
    Field Supervisor

    5,000+ Posts
    • Jan 2014
    • 7879

    [Electrical] Fitting a C454e fuser to a C224e model

    Quick question, is this possible? different part numbers for both fusers but they look the same!?
    Let us eat, drink, and be merry, because tomorrow we may die!

    For all your firmware & service manual needs please visit us at:

    www.copierfirmware.co.uk - www.printerfirmware.co.uk

  • Synthohol
    Certified Konica Expert

    Site Contributor
    5,000+ Posts
    • Mar 2016
    • 5388

    #2
    Re: Fitting a C454e fuser to a C224e model

    i remember the 3 series you could put a faster fuser in a slower model, the heat lamps were a higher wattage, you just couldnt do the reverse because it couldnt keep up.
    the 4 series has no lamps so trial and error? are they geared exactly the same? i never took notice.
    We know a thing or two because we've seen a thing or two.
    The medication helps though...

    Comment

    • copier tech
      Field Supervisor

      5,000+ Posts
      • Jan 2014
      • 7879

      #3
      Re: Fitting a C454e fuser to a C224e model

      Originally posted by Synthohol
      i remember the 3 series you could put a faster fuser in a slower model, the heat lamps were a higher wattage, you just couldnt do the reverse because it couldnt keep up.
      the 4 series has no lamps so trial and error? are they geared exactly the same? i never took notice.

      The 4 series DOES have a lamps, a pair of them.
      Let us eat, drink, and be merry, because tomorrow we may die!

      For all your firmware & service manual needs please visit us at:

      www.copierfirmware.co.uk - www.printerfirmware.co.uk

      Comment

      • Synthohol
        Certified Konica Expert

        Site Contributor
        5,000+ Posts
        • Mar 2016
        • 5388

        #4
        Re: Fitting a C454e fuser to a C224e model

        honestly i never took one apart, i thought the whole induction thing did it all.
        my bad.
        We know a thing or two because we've seen a thing or two.
        The medication helps though...

        Comment

        • copier tech
          Field Supervisor

          5,000+ Posts
          • Jan 2014
          • 7879

          #5
          Re: Fitting a C454e fuser to a C224e model

          I only found this out because I had dead new unit, turns out lamps were broken so fitted another lamp from an old unit!
          Let us eat, drink, and be merry, because tomorrow we may die!

          For all your firmware & service manual needs please visit us at:

          www.copierfirmware.co.uk - www.printerfirmware.co.uk

          Comment

          Working...