bizhub 654e Print Skew Problem

[CopierNerd]

Ever since i replaced the CCDB to fix error code c-9401 the copy from ADF and Glass get skewed few mm. Print outs are tilted side ways very minor. I have checked the precise adjustments given near CCDB but no effect. any suggestion?

Thanks

[tsbservice]

Re: bizhub 654e Print Skew Problem

Do you have manual?
Do you have example?
Did you carry out Main scan zoom adjust as per book after CCDB replaced?

[CopierNerd]

Re: bizhub 654e Print Skew Problem

Thanks Pal!

I have manual.
I have example.
I didn't carry out main scan zoom adjust after CCDB replaced.

The thing i noticed today is, its OK with the letter size but when i make copies on "8.5X13" it gives 2mm tilted print. Half of the print is 100% OK. rest is tilted side ways. whether i copy from platen glass or Document feeder print outs on letter paper size is perfect but on 8.5X13 inch paper it gives slightly skewed print near the end.
Tray 1 same result
Tray 2 same result
Bypass tray same result.

All this started after ccd replaced. Example print attached.

[kingarthur]

Re: bizhub 654e Print Skew Problem

Thanks Pal!

I have manual.
I have example.
I didn't carry out main scan zoom adjust after CCDB replaced.

The thing i noticed today is, its OK with the letter size but when i make copies on "8.5X13" it gives 2mm tilted print. Half of the print is 100% OK. rest is tilted side ways. whether i copy from platen glass or Document feeder print outs on letter paper size is perfect but on 8.5X13 inch paper it gives slightly skewed print near the end.
Tray 1 same result
Tray 2 same result
Bypass tray same result.

All this started after ccd replaced. Example print attached.

I personally wouldn't use a print out from the machine to test skew...you can't tell if it is straight....use the set up sheet that comes with the RADF, you know that is straight....

[CopierNerd]

Re: bizhub 654e Print Skew Problem

This attached image is not the original its the copy. You are saying right man but i dont have that sheet which comes with ADF. Well, it is sure that counter list table was straight when i copied but the result you can see. a bit tilted.
I think i should try main scan zoom adjustment.

[tsbservice]

Re: bizhub 654e Print Skew Problem

Thanks Pal!

I have manual.
I have example.
I didn't carry out main scan zoom adjust after CCDB replaced.

Looks like you answered yourself.

[CopierNerd]

Re: bizhub 654e Print Skew Problem

I admit i missed this step but i am not sure it will work or not. I will surely try! Thanks

[Albonline]

Re: bizhub 654e Print Skew Problem

I admit i missed this step but i am not sure it will work or not. I will surely try! Thanks

run a sky shot, deletion frame will be square, unless paper skew is present.