konica minolta doc feeder df 624 mylar question

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • brent
    Service Manager

    Site Contributor
    1,000+ Posts
    • Nov 2008
    • 1212
    #1

    konica minolta doc feeder df 624 mylar question

    so initially I have been getting quite a few jam code 66-05 which I have learned a ton about today.. so I am in the middle of a situation where my customers
    over the years get a jam in the turn over section and they siimply pull the original out as hard as they can.. and it is bending up that mylar and causing problems so I have a few feeders that I have just replaced and cut the mylar to make it work etc.. I used some info here to see how to get into that turn around section out to replace the mylars? huge job I know.. any thoughts on that procedure?

    I love this site and thank everyone for helping everyone learn etc. thank you

    brent
    Tags: jam, mylar, replace, section, turn
    • Woxner
      Senior Tech

      500+ Posts
      • Jul 2011
      • 840
      #2
      Re: konica minolta doc feeder df 624 mylar question

      I leave the mylars out. works just fine. its one long mylar

        Comment

        • blackcat4866
          Master Of The Obvious

          Site Contributor
          10,000+ Posts
          • Jul 2007
          • 22999
          #3
          Re: konica minolta doc feeder df 624 mylar question

          I made a new mylar for one. I'm not sure how you're supposed to do it ... but I ended up drilling a hole to access the screw that I could not get out:

          PXL_20210406_220549265.jpgPXL_20210406_205017896.jpg

          It was a major operation, even then.
          If you'd like a serious answer to your request:
          1) demonstrate that you've read the manual
          2) demonstrate that you made some attempt to fix it.
          3) if you're going to ask about jams include the jam code.
          4) if you're going to ask about an error code include the error code.
          5) You are the person onsite. Only you can make observations.

          blackcat: Master Of The Obvious =^..^=

            Comment

            • brent
              Service Manager

              Site Contributor
              1,000+ Posts
              • Nov 2008
              • 1212
              #4
              Re: konica minolta doc feeder df 624 mylar question

              thanks guys.. I will see what I can come up with.. I still have these machines in the field they are good for the most part
              lo;



              brent

                Comment

                • tech51
                  Senior Tech

                  500+ Posts
                  • Jan 2009
                  • 846
                  #5
                  Re: konica minolta doc feeder df 624 mylar question

                  Originally posted by Woxner
                  I leave the mylars out. works just fine. its one long mylar
                  I agree. As long as you clean off as much of the glue as possible.
                  It is possible with a little care to drop it in from the top once the top cover feed section has been removed.

                    Comment

                    Previous template Next
                    Working...