Only copies of shooting, sometimes doing a faint copy malfunction middle. (Copy samples are attached.)
-
-
Re: Kyocera km-6030 light copy problem (print no problem)
So it's ok on prints? Then you are looking at the optical section. What have you done so far? -
Re: Kyocera km-6030 light copy problem (print no problem)
What is the feed direction LTR or LTR-R (A4 or A4-R)?
I'm going to take a WAG that it fed LTR-R/A4-R and it could happen on prints, just that it's intermittent and you saw the copies first.
It looks to me like a charge contact issue. It could be the developer bias contact or the transfer charge contact. You can use conductive grease on the transfer charge contact, but cannot use conductive grease on the developer bias contact.
A search might have brought you to this thread:
http://www.copytechnet.com/forums/ky...-copystar.html
http://www.copytechnet.com/forums/ky...tml#post451838
=^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: Kyocera km-6030 light copy problem (print no problem)
feed direction is A4,not reduction.I changed the ccd card.Last edited by alpertevfik; 09-04-2016, 12:39 PM.Comment
-
Re: Kyocera km-6030 light copy problem (print no problem)
the problem continues.
Does anyone ever encountered this problem?
Comment
Comment