TASKalfa 4052ci- fusing unit

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • RandyW
    Trusted Tech

    100+ Posts
    • Jan 2013
    • 213
    #1

    TASKalfa 4052ci- fusing unit

    Checking if parts are available for the fuser units.

    Looking at the parts book I have it just shows the whole fuser unit.

    thanks
    Tags: book, fuser, parts, shows, unit
    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 22973
      #2
      Re: TASKalfa 4052ci- fusing unit

      That's it, the assembly, and it's been updated a dozen times. Will they get all the bugs out of it? I suspect yes, eventually. =^..^=
      Last edited by blackcat4866; 10-28-2022, 09:19 PM.
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

        Comment

        • Larhal
          Semi Retired

          Site Contributor
          VIP Subscriber
          500+ Posts
          • May 2013
          • 541
          #3
          Re: TASKalfa 4052ci- fusing unit

          Originally posted by blackcat4866
          That's it, the assembly, and it's been updated a dozen times. Will they get all the bugs out of it? I suspect yes, eventually. =^..^=
          And don't forget the "rust".
          Larhal

          Retired Part Time

          If all else fails read the Service Manual!

          If that fails, meet me at the pub and we will discuss it.

            Comment

            • RandyW
              Trusted Tech

              100+ Posts
              • Jan 2013
              • 213
              #4
              Re: TASKalfa 4052ci- fusing unit

              Do those machines have problems scanning? Working than not working?

              I told our account there's not much we could check for that and they should call their IT people.

                Comment

                • davidmtupper
                  Trusted Tech

                  250+ Posts
                  • Jul 2021
                  • 326
                  #5
                  Re: TASKalfa 4052ci- fusing unit

                  Originally posted by Larhal
                  And don't forget the "rust".
                  Yup, start seeing that and get ready to replace the fuser. It WILL start throwing 6600 codes soon.

                    Comment

                    • sparkycivic
                      Trusted Tech

                      250+ Posts
                      • Apr 2017
                      • 348
                      #6
                      Re: TASKalfa 4052ci- fusing unit

                      Originally posted by Larhal
                      And don't forget the "rust".
                      Once the rust runs out, c6600 'low rust level' is achieved.

                      I tore a rusty one down, it was the bearings spinning on the shaft of the press roller, grinding it down and creating the rust, mixed with the dried grease from inside the sealed bearing units.

                      Too bad they are press-fit and with only a clip to keep them located longitudinally. I'm sure the temperature swings work against keeping the inner-race seated on the plain shaft allowing them to spin, but then again the bearings are overheated and dried out anyhow. lots of design issues regarding that...

                        Comment

                        Previous template Next
                        Working...