Larhal
Retired
Last Activity: 4 hours ago
Joined: 05-03-2013
Location: At the Pub, Ireland
-
You need to stop using the compatible toner, I venture to say the transfer ports on the ITB belt are clogged up again. Remove the belt, vac out the ports... -
Welcome to the community.Leave a comment:
-
Which toner did you have in when it gave the message? Compatible or OEM?Leave a comment:
-
Here in the EU the chips are different. In the beginning when the IMC's first came out they used MPC toner. then they phased in a different chip and ...Leave a comment:
-
The MPC3503 , IMC3500 and IMC 3010 are all the same toners. Chip is different and there is a difference in the cartridge collar.Leave a comment:
-
I Like that one, So tired of holding the penlight with my teeth.
...
Leave a comment:
-
As a technician, can you tell us what you have investigated or done to troubleshoot this very vague issue? Help us help you.Leave a comment:
-
Welcome to the community. You will find a lot of knowledge is here. You just have to look and then tell us your problem and what you have done to try...Leave a comment:
-
Remove the transfer belt and vac out the toner supply tubes. This will eliminate one potential problem. And by all means do not use compatible toner ...Leave a comment:
-
I had a similar toner dousing at an executive office. Xerox 3100 LDC. Key operator, very familiar with adding toner, had trouble removing the cap. Cap...Leave a comment:
-
Welcome to the community...Leave a comment:
-
Nathan, Maybe you should post and introduction in the Newbie introduction forum. That way you introduce yourself to the community.Leave a comment:
-
Welcome Back to the community.Leave a comment:
No activity results to display
Leave a comment: