mpc5502 "replace fuser roller "

[digicor]

Re: mpc5502 "replace fuser roller "

i do that too on all the '02'03's i guess the nvram is corrupt, ill re do it and c if that works

[fshead]

Re: mpc5502 "replace fuser roller "

can you copy nvram from another mpc5502 and and see if that works?
i would take an image of the existing machine before and drop it on my laptop.
I take copies of nvrams on all my mpc3002/mpc3003 s i resell now.
It sucks having a charge call where you just replaced over $500 WORTH of parts and cant get it to work.

[digicor]

Re: mpc5502 "replace fuser roller "

i also have done this
I think its in the NV ram.... but i dont want to think that until ive exhausted all other possibilities

[copier tech]

Re: mpc5502 "replace fuser roller "

Try manual new unit set SP3902-xx & set the pressure roller from 0-1 & restart the machine.

[digicor]

Re: mpc5502 "replace fuser roller "

yes i did, the pm count on the fuser is 2, its a new rebuilt fuser, all new fixing film and LFR,thermisters, ...
i used a re set fuse, followed proceedures i use typically on these machines, never had this problem,
any other ideas?

[FrohnB]

Re: mpc5502 "replace fuser roller "

What was the PM count on the fuser?
Did you Cycle Machine after resetting counters SP 7-804-019 and 022 and 023? (Off/On).

[digicor]

Re: mpc5502 "replace fuser roller "

thank you but yes i have done all that too

[fbkhan3]

Re: mpc5502 "replace fuser roller "

If you have done everything said above,just try to reset the PM or Parts counters for fuser Roller and restart.


Hope that helps.
Regard's

[digicor]

I have re set the fuser several times, with fuse, re set all counters, including 390*/7-***/ all that i know how to re set, even the one in 1-***
still wants new fuser roller, Its been a while is this an NV ram issue? or is there a procedure in a certain sequence thats need to be done? i cant see having to put a new fuser in it? ive been rebuilding these units for a while, and re setting with fuse, or my little cheat fuse i made out of a thermister... Please advise Thanks