If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
It's a small straightforward A4 black and white machine. Most likely culprit is , drum unit, Dev unit, LED array / laser unit.
Drum unit and Dev unit is very easy to check. Just open the front door and slide out. While you doing that just check for a build up dirt and toner inside the machine and clean it out.
This job is so simple I made a HOW TO guide for customers to carefully clean it. Saved me many call outs, until the PCDU starts causing lines etc then obviously I have to go out replace, update firmware and clean LED flip down section.
Would only recommend if you trust the customer enough though, there are some I can't trust to even change a toner on this model
Comment