Ricoh af-3260 sc*543

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Polo-022
    Trusted Tech

    250+ Posts
    • Sep 2007
    • 484
    #1

    Ricoh af-3260 sc*543

    I have already replaced hot roller thermistor assy and tomorrow i will replace fuder harness from PSU to fuser module as a Ricoh bulletin suggests for some SC-xxx codes.
    This code appears randomly after a complete print or copy job.
    Does anyone have faced the same issue?
    Thanks for any input!!
    Last edited by Polo-022; 03-17-2010, 08:03 PM.
    Tags: 260, 326, 3260, 543, assy, ats, bulletin, bypass tray, codes, copy, fuser, harness, hot, incorrectly, issue, job, module, print, printer driver, psu, replaced, ricoh, roller, sc992, shortcuts, symptom, thermistor
    • Herrmann
      Senior Tech

      Site Contributor
      500+ Posts
      • Jan 2006
      • 792
      #2
      Make sure that you are running at least engine firmware 1.20.2.08:

      1.20.2:08
      Symptom corrected:

      1.Poor fusing sometimes occurs when the PS printer driver or EFI PS printer driver is used.
      Note: See RTB #RB132020a for the procedure.

      Important: To apply this change, install the following firmware:
      - Engine v1.20.2:08 (B1325402Q) or newer, AND
      - System/Copy v1.23.1 (B1325750M) or newer.

      2. SC543 sometimes occurs if the bypass tray runs out of paper.
      Note: When using System_Copy versions v1.21 or older, this SC was incorrectly displayed as SC992.

      Important: To apply this change, install the following firmware:
      - Engine v1.20.2:08 (B1325402Q) or newer, AND
      - System/Copy v1.22 or newer.
      the newest version is: 1.23.0.08

      good luck
      If sometimes you feel a little useless, offended and depressed always remember that you were once the fastest and most victorious sperm of hundreds of millions!

        Comment

        • Polo-022
          Trusted Tech

          250+ Posts
          • Sep 2007
          • 484
          #3
          It is running the latest firmware version : 1.23.0.08. i confirm. (By the way, there is no luck in this job, just revenge from the beasts!!)
          I replaced the fuser harness today without success, heaters, thermostats checked by ohmmeter, ventilation fans and filters...
          Thank a lot for your reply!

            Comment

            • Herrmann
              Senior Tech

              Site Contributor
              500+ Posts
              • Jan 2006
              • 792
              #4
              ok, lets try to get logical
              error 543 means, that there is a massive temperature rising wihtin 1 second, so you can exclude everything which leads to an interruption of wires because this will lead to undertemperature errors, not overtemperature. I would check the wiring at the backside of the mashine, beginning from the fuser connector up to the bicu and search for shortcuts against the frame at next.

              Give it a try
              If sometimes you feel a little useless, offended and depressed always remember that you were once the fastest and most victorious sperm of hundreds of millions!

                Comment

                Previous template Next
                Working...