Lanier ld075 ( richo aficio 1075)

[copierlady]

Working on lanier ld075 ( richo sficio 1075) need to remove the fuser to take it to the shop. What am i missing here? Right side i see to release with black release bar, but the left side has no release that i can see. Any clues for me? Thanks

[Vulkor]

Take off Blue Knob. Take off Brown front cover. Unplug Fusing Web Harnesses (3). Uncrew small bracket on rear top of fusing unit that holds it in. Lift up on unit.

[teebee1234]

!Watch out for the sensor on the lower front section of the fuser when lifting it! I don't know how many times I've broken it when it got snagged during removal (due to my impatience of course).

[Eric1968]

!Watch out for the sensor on the lower front section of the fuser when lifting it! I don't know how many times I've broken it when it got snagged during removal (due to my impatience of course).

You are absolutely right! Happened to me a few weeks ago (impatience...).

[copierlady]

Thanks guys! I WILL WATCH FOR THAT SENSOR. IMPATIENCE? ME?*!
I'll tackel it again on mon. Have a great weekend.

[tcs04]

Thanks guys! I WILL WATCH FOR THAT SENSOR. IMPATIENCE? ME?*!
I'll tackel it again on mon. Have a great weekend.

2 tips (obvious?)

Stick an allen key through the hole in the roller shaft to get the knob off,

Swing the toner bottle out before lifting, it helps you to remove the unit without breaking the sensor!

[tcs04]

Thanks guys! I WILL WATCH FOR THAT SENSOR. IMPATIENCE? ME?*!
I'll tackel it again on mon. Have a great weekend.

NEWSFLASH!!!! NO PRESSURE RELEASE SENSOR ON THE AF1075!!!!!!... only on the 2075!

[copierlady]

Ok guys got that fuser removed. Any tips on taking it apart for a rebuild? Also i noticed that the web is not advancing like it should there is quite a build up on the web. Gears look ok. Any ideas?