[CQ] MX-2700n bell shaped impression on copies and prints

[ohightower]

nonreply_20141124_143601-page-001.jpgnonreply_20141124_143601-page-002.jpgnonreply_20141124_143601-page-003.jpgnonreply_20141124_143601-page-004.jpgWhats causes this?

[serviceman]

Re: MX-2700n bell shaped impression on copies and prints

I would start with the transfer belt.

[mttech]

Re: MX-2700n bell shaped impression on copies and prints

Check your primary transfer belt for something stuck to it.

[ohightower]

Re: MX-2700n bell shaped impression on copies and prints

I check the primary and the secondary transfer belt it had that impression on it but it would go away when it cleans itself. This impression only comes like every five copies. The other copies are nice and clean could it just be the drum needs to be replaced or something else?

[serviceman]

Re: MX-2700n bell shaped impression on copies and prints

When you say you checked the primary belt, did you actually pull it all the way out of the machine? Or just ran blank copies through? I'm fairly certain your issue will be found in the primary belt. A crack in it or the thin sides of a label stuck to it...

[faxman28]

Re: MX-2700n bell shaped impression on copies and prints

I check the primary and the secondary transfer belt it had that impression on it but it would go away when it cleans itself. This impression only comes like every five copies. The other copies are nice and clean could it just be the drum needs to be replaced or something else?

If it's every five copies ,I would talk a very close look at the primary transfer belt, remove and turn by hand. if it was drum it would be repeating on the page . like others mentioned it is usually label stuck to belt, i have also seen broken belt cause this similar image quality.

[blackcat4866]

Re: MX-2700n bell shaped impression on copies and prints

The only thing long enough to make a repetitive image that long is the primary transfer belt. My guess is that the belt has delaminated (layers separating) and it's no longer flat, and no longer cleaning properly. =^..^=

[NeoMatrix]

Re: MX-2700n bell shaped impression on copies and prints

Please keep us informed of the result.

[Foxhound]

Re: MX-2700n bell shaped impression on copies and prints

Blade flip? deffinately X-fer belt unit. Run full color if you get Brown in the bell area its blade flip.

[ohightower]

Re: MX-2700n bell shaped impression on copies and prints

I replaced the primary transfer belt unit and that fixed the problem thanks for all the help!

[lenovos]

Re: MX-2700n bell shaped impression on copies and prints

[ATTACH=CONFIG]27223[/ATTACH][ATTACH=CONFIG]27224[/ATTACH][ATTACH=CONFIG]27225[/ATTACH][ATTACH=CONFIG]27226[/ATTACH]Whats causes this?

I replace the whole transfer belt, but a new cleaning will probably solve the problem.