Ir4570 copies upside comes very lighly????

[Mikey]

Re: Ir4570 copies upside comes very lighly????

I will not say that CCD board is defective because you are able to get scanned image quality. I wouldn't say laser either.

Is half of the image comes lightly?

If yes, then you might have loose connection on the circuit board. First, check the CCD board and or after the CCD board where the switching IC is located for both between the scanned image and copy image. If you have the diagram you may be able to find it easily. Should there be no loose connection, then you have to replace the board where the image switching IC is located.

[spectraindo]

Re: Ir4570 copies upside comes very lighly????

Try replacing the High Voltage Unit and the whole Right Door Assy.

[susanta_gaan]

Re: Ir4570 copies upside comes very lighly????

it is both (copy and print)

[mrfixit51]

Re: Ir4570 copies upside comes very lighly????

it is both (copy and print)

Do you realize that the thread is almost 3 years old?
Best to jump into conversations that are current, instead of poking in the ashes...

[zoraldinho]

Re: Ir4570 copies upside comes very lighly????

Do you realize that the thread is almost 3 years old?
Best to jump into conversations that are current, instead of poking in the ashes...

welcome back.jpg

[mrfixit51]

Re: Welcome back!

[ATTACH=CONFIG]24657[/ATTACH]

Thanks! I do from time to time check in, but do to a manager change,

(read you are not gainfully employed unless you are running around
with a screwdriver in your hand and your hair on fire here),

I have very little time to lend or receive assistance from the forum...

I long for yesteryear...



mrfixit51

[Mikey]

Re: Ir4570 copies upside comes very lighly????

I'm your buddy in the other part of the world. Have a nice day.