BIZHUB C250i POOR FIXING

[COPIERTEC ASSOCIATES]

Hello comrades, am working on the above but having a challenge of not fixing the copy.
The copy comes out but not fixed,the text just rubs off.
work around; 1. removed the fixing unit replaced fixing film,adjusted fixing temperature to maximum to no vail.
I have rebuilt the fixing unit but same problem still persists .
upgraded firmware,but still no success.
Any assistance much appreciated

[Thib]

Verify that both black & all colors aren't fusing. Had one last month that I was only printing black test pages. Ended up being the black toner that the customer bought off amazon. If I had printed a demo page I would have saved myself hours of time. If neither are fusing to the page properly it's the fuser. I've had a few like that lately.

[Woxner]

there are new style fusers that will take care of this problem. it comes with a shim and engine settings, after market will make this problem worse

[Duplicator]

The i-Series has had a rough time with fusers... There has been 3 revisions in our area of the world so far.

there are new style fusers that will take care of this problem. it comes with a shim and engine settings, after market will make this problem worse

You will also need a new enough version of the firmware to make use of that switch.

[KMFLT3CH]

Just replace it, don't waste your time. These fusers are garbage. i-Series New Fusers.pdf

There is a good reason why KM removed the expected yield number from the consumables by model pdf for all the 0i models.. because the fusers don't even make 1/3 of their expected yield 😂 Consumables by Model 11-2024.pdf

[Woxner]

newest fuser number AA2JR75200

[Ziggy]

if you have not fusing properly you can turn on engine switches 35 and 57. The engine switches can be found under the advanced security settings. Service mode the press Stop>0>C

[Oystercopy]

I don't suppose its bad, generic toner, right?
OC