[Jamming] bizhub C458 ADF Paper Jam 66-02

[kaisa]

The paper is not being fed. As soon as I apply pressure to the top cover, the feed works.
I've already replaced the feed rollers and seperation roller. Does anyone have a solution for this?

[occus]

You changed already the torque limiter of the sep. roller?
Maybe this helps.

[kaisa]

Yes, I replaced it

[KMFLT3CH]

The top cover latches down via two metal pins. The one at the back probably needs to be bent down a tad so the drive gears mesh better. If when you press down on the cover you notice a lot of play, then try the pin.

[copyman]

The top cover latches down via two metal pins. The one at the back probably needs to be bent down a tad so the drive gears mesh better. If when you press down on the cover you notice a lot of play, then try the pin.

..... Or make sure ADF top door rear latch hook isn't broken

[kenpio]

Make sure the black patch by the slit glass is clean. That flips down and you can see it.

[blackcat4866]

Dusty document empty sensor PS1. Clean dust from PS1 in the original tray.

[Albonline]

The top cover latches down via two metal pins. The one at the back probably needs to be bent down a tad so the drive gears mesh better. If when you press down on the cover you notice a lot of play, then try the pin.

I had to adjust quite a few of these pins on new out of the box units at setup.

[ltdiniz]

I was here looking at AllSolutions and found this page, I hope it helps you.

[copyman]

I was here looking at AllSolutions and found this page, I hope it helps you.

This bulletin looks like it's exclusive for statement size paper 5.5 x 8.5 when using with mixed original feature?