The i series will push me into retirement

[KMFLT3CH]

Also, can anyone remind me, when setting the "bit" for the switch, I know it goes from right to left, but does it go from 0 to 7, or 1 to 8

Right to left starting at 0 and ending with 7.

[Black Cloud]

Right to left starting at 0 and ending with 7.

You can input the binary number, but it is easier to input the number in Hex.

[tsbservice]

Has anyone changed the software switch for the 5372 error, the "Read me" for the FW says

image.png

I was looking at the service manual, for something else, when I spotted this

image.png
Also, can anyone remind me, when setting the "bit" for the switch, I know it goes from right to left, but does it go from 0 to 7, or 1 to 8

We did it since they started to fail on A3 devices Sw187 to 40.

[kingarthur]

You can input the binary number, but it is easier to input the number in Hex.

Unfortunately I don't have the HEX for that switch, and it's been a while since I had to do binary biggrin.png

[kingarthur]

We did it since they started to fail on A3 devices Sw187 to 40.

That's why I'm asking the bulletin says switch 187, but the manual says 189 - switch 187 is for something completely different, it's for image quality. I've found a later bulletin that says to change 189 - not 187

[tsbservice]

That's why I'm asking the bulletin says switch 187, but the manual says 189 - switch 187 is for something completely different, it's for image quality. I've found a later bulletin that says to change 189 - not 187

Bulletin is for A3 models and service manual you mentioned is for A4 models. Not the same my friend, not the same

I know it's really confusing as Konica Minolta patched one after another mistake.

187 hex 40 does nothing on A4 device instead we should use Sw 189 to set fan turning(constant noise) or not.
Plus on A3 models we can set CPU fan run half speed/full speed or not at all while on A4 it's only ON/OFF.

I know it's a mess but we are techs and should clean all sh.ts they throw at us