C300İ sound problem

[Ghostlover34]

Hi bro

There is a noise coming from the front of the Konica C300i model even though the machine has been newly installed. The machine only works for 60 thousand and I have this problem with most 300i models.

I added the audio video

https://youtube.com/shorts/ohOoZpLeU34?feature=share

[Massimiliano]

Hi,
from the video it seems like a problem with the waste toner mechanism.
I'm attaching the bulletin, I solved it with this method

[Ghostlover34]

hi bro

is this ?

11.jpg

[Massimiliano]

hi bro

is this ?

11.jpg

Yes!
jpg I can't open

[kenpio]

Have run into this a lot. I took it apart, 12 screws to get to it. Careful not to tip it when you get it apart, the covers fall out, two sizes. After that pretty straight forward.
Thanks

[Synthohol]

i used to just cut 2 or 3 loops off the shutter spring on the box and it usually fixed the issue with toner backup.

[kingarthur]

Have run into this a lot. I took it apart, 12 screws to get to it. Careful not to tip it when you get it apart, the covers fall out, two sizes. After that pretty straight forward.
Thanks

12 screws? - I only remove 3 , then you just remove the part that covers the 3 gears biggrin.png

[tsbservice]

12 screws? - I only remove 3 , then you just remove the part that covers the 3 gears biggrin.png

Same here.

[kenpio]

Guess I will look again.....

[Ziggy]

see attached bulletin

[Woxner]

I just spray some lube on these gears. No need to take anything apart

[tsbservice]

I just spray some lube on these gears. No need to take anything apart

Nah we used to do that until it just didn't worked on one machine. We carry the part with 3 gear shafts lubed and prepared just to be fit at site.

[Boyaka1989]

Hi bro

There is a noise coming from the front of the Konica C300i model even though the machine has been newly installed. The machine only works for 60 thousand and I have this problem with most 300i models. I think the sound is coming from the waste toner box. Has anyone experienced this?

I added the audio video


https://youtube.com/shorts/ohOoZpLeU34?feature=share

goodmorning

i had this issue with some c300i and c360i i just hit the side of the gears with hand and it stopped squiking.