MINOLTA BH284e ADF

[M1963]

Well can you at least tell us what solved the issue???

greetings

nothing helped
the values
4 and 2 were ok
i installed another firmware
the voltage on the connector is ok

[Synthohol]

fwiw ive had to replace at least half a dozen DS boards with similar symptoms.
i found that if you unplug the HDMI cable from the DS board and boot up. if no codes the DS board is likely toast. if it does code out id just reseat the board on the mfp and try again.

[tsbservice]

fwiw ive had to replace at least half a dozen DS boards with similar symptoms.
i found that if you unplug the HDMI cable from the DS board and boot up. if no codes the DS board is likely toast. if it does code out id just reseat the board on the mfp and try again.

It's not dual scan DF. Just regular DF624. Plus he did tried another DF.

[Synthohol]

aww fudge...
if you add the board and a 701? will it see it?
does ADF show up in service mode at all? not system 2, i mean the main sm page
any 24v at the connector?

[M1963]

does not show ADF in SM window
voltage 24V is ok
everything worked before battery replacement

[ltdiniz]

Hello!
Why did you change the MFPB battery?
What was your procedure after changing the battery?
Did you use any reset tool on this device?
But let's get to the basics, ok?
Perform a memory clear on this device and see if it enables the option in system 2 service mode and configure it again.

[M1963]

Hello!
Why did you change the MFPB battery?
What was your procedure after changing the battery?
Did you use any reset tool on this device?
But let's get to the basics, ok?
Perform a memory clear on this device and see if it enables the option in system 2 service mode and configure it again.

hello,
the machine asked me to enter the printer and scanner serial numbers, the cause of this is a dead battery.
i didn't use the reset tool, i just entered the serial numbers and
DIP sW 10 hex 02
i don't understand why the counters reset

[copyman]

Usually when it loses serial # all the meter counts are lost. I always use the reset tool with dead battery. I've even brought 4 series machines back to life without replacing the battery. Just can't turn machine off for long once you get it back working.

[M1963]

94 / 5,000
I would like to try the latest firmware version so I would like someone to send it to me. BW BH284e

[ltdiniz]

hello,
the machine asked me to enter the printer and scanner serial numbers, the cause of this is a dead battery.
i didn't use the reset tool, i just entered the serial numbers and
DIP sW 10 hex 02
i don't understand why the counters reset

Perform the reset using the reset tool and all the equipment's default settings.
Using the most current firmware you have on hand.
Until someone makes a more recent version available here on the forum.

[M1963]

firmware A61F0Y0-F000-G20-M1 Does it support SMB 3.0 ?

[tsbservice]

firmware A61F0Y0-F000-G20-M1 Does it support SMB 3.0 ?

No.