MINOLTA BH284e ADF

[M1963]

greetings.
machine does not see ADF 624
problem occurred after battery replacement
SYSTEM 2 SELECTED DF624
DOES ANYONE HAVE AN IDEA

thanks

[Woxner]

Go into system 2 and look for df settings. Select df you have

[tsbservice]

Could be DF isolated?

[copyman]

Remove rear ADF cover and check connector. I've had a few off lease machines that the ADF cable was pulled when moved which disconnected it from the ADF board.
Also you can try initializing the machine. Service mode, sys 1

[M1963]

Go into system 2 and look for df settings. Select df you have

I already did that.
is there a DIP SW to activate the ADF?

[M1963]

Remove rear ADF cover and check connector. I've had a few off lease machines that the ADF cable was pulled when moved which disconnected it from the ADF board.
Also you can try initializing the machine. Service mode, sys 1

I tried with another ADF.
the machine was working normally before replacing the battery

[copyman]

I tried with another ADF.
the machine was working normally before replacing the battery

Did you initialize the machine? Service mode, system 1

Also when ever I've replaced the battery I had to do complete new machine setup, machine type, etc etc

[M1963]

Did you initialize the machine? Service mode, system 1

Also when ever I've replaced the battery I had to do complete new machine setup, machine type, etc etc

thanks for the support
I thought about that possibility but I don't have the MACHINE and TYPE data for BH284e, maybe you do?

[femaster]

thanks for the support
I thought about that possibility but I don't have the MACHINE and TYPE data for BH284e, maybe you do?

Screenshot from the manual covering all 3 of the slower Color 4e machines.

image.png

[tsbservice]

thanks for the support
I thought about that possibility but I don't have the MACHINE and TYPE data for BH284e, maybe you do?

That may be your problem wrong machine type!

[M1963]

Screenshot from the manual covering all 3 of the slower Color 4e machines.

image.png

unfortunately this table does not suit me, I need it for the black and white machine BW BH284e
serial number starts with A61G02-
Can I change these parameters without resetting or upgrading the firmware?

[tsbservice]

Here you are:
Clipboard010.jpg

Should be 4 and 2 in your case.

[femaster]

unfortunately this table does not suit me, I need it for the black and white machine BW BH284e
serial number starts with A61G02-
Can I change these parameters without resetting or upgrading the firmware?

Crap, sorry about that. I swear I saw color somewhere in the thread, so my mind was focused on the color models. I see TSBSERVICE got you covered though. Hopefully that gets you back up and running.

[M1963]

Crap, sorry about that. I swear I saw color somewhere in the thread, so my mind was focused on the color models. I see TSBSERVICE got you covered though. Hopefully that gets you back up and running.

all ok

thank you

[copyman]

all ok

thank you

Well can you at least tell us what solved the issue???