scanner image whacked

[digicor]

Re: scanner image whacked

yeah, im thankful its home is in a home office,, nice ac not much action,, lol

[DRichard]

Re: scanner image whacked

I have also seen lazy customer employees lean on the front of the machine while they are using it.

...or leaves a case of paper on top of the copier...

[tsbservice]

Re: scanner image whacked

...or leaves a case of paper on top of the copier...

Lazy customer won't go that high he will drop it down but sturdy stupid is another thing

[Tony in Oz]

Re: scanner image whacked

Remove the left hand scanner side covers & you will see a bunch of screws holding the scanner in position, tighten all when u have the scanner in the correct position

[GIUBOSS]

Re: scanner image whacked

You can also use a simple bubble level for the platen glass and MFP

[Gift]

Re: scanner image whacked

okay thats the ticket, it was way bent down, and i bent it back, good quality, but, the scanner is definitely loose in the corner, i can just lean on it and it moves down,, any fix for this? i guess if the client doesnt do a butt shot it should be okay
[ATTACH=CONFIG]53051[/ATTACH][ATTACH=CONFIG]53052[/ATTACH][ATTACH=CONFIG]53053[/ATTACH]

You can use that scanner support thingy for transport if there's no finisher / internal stuff installed.

Imgur: The magic of the Internet

If the installation was made properly this part hasn't been dumped but clipped on the inner side of the front door.

It's also possible to loosen a bunch of screws between the scanner and machine frames and re-tighten them while lifting up the front/left corner.

[Mark Bbb]

Re: scanner image whacked

You can use that scanner support thingy for transport if there's no finisher / internal stuff installed.

Imgur: The magic of the Internet

If the installation was made properly this part hasn't been dumped but clipped on the inner side of the front door.

It's also possible to loosen a bunch of screws between the scanner and machine frames and re-tighten them while lifting up the front/left corner.

Jep, that's the one!
My bet is on this fix

[tonerhead]

Re: scanner image whacked

Glad you got it figured out. I haven't had to do a "chiropractic" adjustment on a copier for years. Customer must have really pushed down on the corner of machine

[luca72]

Re: scanner image whacked

I have also seen lazy customer employees lean on the front of the machine while they are using it.

I always lean there too ... but then I straighten it (LOL)