arm-450n first tray copy issue

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • DINGO
    Senior Tech

    500+ Posts
    • Nov 2007
    • 661
    #1

    arm-450n first tray copy issue

    Hello

    I'm here again to bother you with a new problem in a arm-450n, and because i have difficulty to explain to me in english i post the issue in attachements.

    -only hapenned of the first tray, n the others tray everything ok.

    In advance i post what i already do:
    -I chek and replace every three rollers, and including to, a new spring pressure of the reverse roller.
    -Ichek the black plastic in the left door, ( that press the guide of the first tray).
    .
    -I make a copy whith the left door open, and the paper finds no bar, pass ok

    Can somebody give me any idea what be be more?

    thanks in advance
    Attached Files
    Tags: 450, 450n, adjust, arm, black, copy, copyi, door, english, guide, including, issu, issue, lef, left, open, paper, pass, plastic, pressure, replace, reverse, rollers, size, spring, tray
    • spotlifter
      Technician

      50+ Posts
      • Mar 2008
      • 65
      #2
      What happens if you try print? Does it have same issue as copying?
      Cause I'm seeing you are copying from scanner.

      I had some problem same as your 1st tray but it is jamming every 2nd paper. When I do duplex, no jamming, only 1 sided copy will jammed. What I did was : -
      Removed the main drive box and serviced the 1st tray clutches.
      (Hard work here, while I'm there I serviced all the clutches as well.)

      I'm not sure my image was shifting. Try sim50-12?
      sigpic

        Comment

        • DINGO
          Senior Tech

          500+ Posts
          • Nov 2007
          • 661
          #3
          re

          ok

          Was what i started doing, just leave the question in the forum.
          Tomorrow i finish, and then say something.

          About your question, yes the issue is the some in print, make sense a service at first tray clucht, very very hard work.

          thanks friend.

            Comment

            • blackcat4866
              Master Of The Obvious

              Site Contributor
              10,000+ Posts
              • Jul 2007
              • 22996
              #4
              "99" is a bit too high for tray #1 buckle in 51-2. Try a setting of "85" before continuing with your troubleshooting. =^..^=
              If you'd like a serious answer to your request:
              1) demonstrate that you've read the manual
              2) demonstrate that you made some attempt to fix it.
              3) if you're going to ask about jams include the jam code.
              4) if you're going to ask about an error code include the error code.
              5) You are the person onsite. Only you can make observations.

              blackcat: Master Of The Obvious =^..^=

                Comment

                • DINGO
                  Senior Tech

                  500+ Posts
                  • Nov 2007
                  • 661
                  #5
                  re

                  Hello good friends.

                  Today , i finish the main drive service, ( gears, clutches and so) and now evrything ok, the 51-2 was now in value normal.

                  good night

                    Comment

                    Previous template Next
                    Working...