sharp ar-286 H5-01 error code HELP???

[blackcat4866]

Maybe you should find out why it jams every time? A reset is only indicated here when you solve your jamming problem. For example, Is there a lead edge void on prints? No void means heat roller wraps every time. Broken or out of position pawls? Teflon worn off the heat roller? Is gear 48T melted and/or deformed due to overheating? Is the bed handle broken by rough handling by the customer? Does the exposure lamp light too slowly, causing a black leading edge on every copy? Is paper wrapped around the rollers or the lower roller impaled by a fuser pawl, stopping rotation?

And that is just the common causes. =^..^=

P * C * 14 Then 1 For Yes And Follow On Screen Directions, Code Should Clear Out.

Jamie

I tried this to clear my H5-01 error on my AR-286, but nothing works.

To clarify:
P is the Program button
C is the Clear button
Is there a button for the * or is that just a separator for button hits?

Thanks!

[JDE75]

P * C * 14 Then 1 For Yes And Follow On Screen Directions, Code Should Clear Out.

Jamie

What is the point in just 'Re Setting' an Error code, If you don't know WHAT it means and WHAT happened to cause the Error code in the First place.................... ???


Ps
MX code won't work on a Cougar

I guess it's just to "temporarily" solve the problem and wait til I have the money to fix the machine. :-)

[johnbla]

What is the point in just 'Re Setting' an Error code, If you don't know WHAT it means and WHAT happened to cause the Error code in the First place.................... ???


Ps
MX code won't work on a Cougar

reset code for h5-01

I don't know if this will work for your model but on a sharp mx-2700n
pressing #p * c * then 14 execute press blk/wht button then press CA will reset a code h5-01. I had a bad paper jam in the fuser that set the code.

[nightshade]

I'm sorry...i'm really new to this and dont even know where is the F-section. What are the Engr/sim codes to reset?

Thanks

F-Section. Means the fusing section.

The service code H5-01 needs to be reset by a technician. So you may wish to call your local Sharp authorized service supplier.

H5-01 is 5 continuous jams in the F-section and requires full examination of F-section and Left door assembly, for root cause.
It will need Engr/Sim codes to re-set the machine.

I'm sorry...i'm really new to this and dont even know where is the F-section. What are the Engr/sim codes to reset?

Thanks

[johnbla]

H5-01 is 5 continuous jams in the F-section and requires full examination of F-section and Left door assembly, for root cause.
It will need Engr/Sim codes to re-set the machine.

Hi,

Please help.....I think it's a fuser jam error......I cleared the jams already but still have that "Call for service" message.

Thanks