"Massive" deal?..
Really?...
That's not the way the ROW sees it.. especially not Ireland... 🙄...
ThisPete
Too old to care
Last Activity: 13 minutes ago
Joined: 06-15-2014
Location:
-
Do the CCD's have the same part number?Leave a comment:
-
That sounds familiar to me too.....Leave a comment:
-
For what it's worth, years ago I had a similar issue with a 224e/308 that wouldn't take all of the firmware 'modules'.. John Eckenhoff (U.K. tech specialist)...Leave a comment:
-
🍿......Leave a comment:
-
mmm.. I smell SPAM!!......Leave a comment:
-
ROFLMFAO!!! 🤣...Leave a comment:
-
Leave a comment:
-
The 'soft' part of knees are the best tool I've found for locating dropped screws though... 🙄Leave a comment:
-
I have seen many times over the years that lessening the pre-load of the primary feed or double feed prevention rollers helps prevent double sheet feeding.....Leave a comment:
-
I've been hearing that line for ~35 years, bearing in mind how (generally) good modern copiers are.. they must have been f***ing brilliant years ago!!!...Leave a comment:
-
Hi Thorsten_300ci, it's usually found 'hidden/hiding' in the 'Appendixes' section at the end of the manual.. no idea why... 🤷♂️Leave a comment:
-
Measure the distance between same looking marks and use the 'Repetitive Defects Gauge' in the manual.Leave a comment:
-
P.S. Punctuation helps people understand what you've written far better..
Just a thought.... 😘Leave a comment:
-
I did add to the thread.. perhaps you didn't read it ALL properly?..
200km is not much for an install..
250 MILES in one day...Leave a comment:
-
Using KMNV isn't complicated...
Get rid of the sales 'person' if they can't grasp it..
Or, buckle up and act like a proper company.......Leave a comment:
-
So, do you just use a 'man and van' to do the delivery, with no presence from your company?...Leave a comment:
-
KFS can do most of it IIRC..
NetViewer(ing) it is hardly time consuming, just get the engineer to turn up shortly before the actual delivery...Leave a comment:
-
KM NetViewer is a good shout, just be aware of this thread if wanting to use it on some of the new MZ range: https://www.copytechnet.com/forum/techni...Leave a comment:
-
I've had problems with scanning to email on Konica Minolta's in the past if nothing was in the 'body' of the email, just a thought.. 🤷♂️Leave a comment:
No activity results to display
Leave a comment: