Trouble code c0204 on km c250i

[Esron Thomas]

Hi guys I've got a Trouble Code C0204 on konica minolta bh c250i, I tried check for paper jammed, and debris, but nothing, tried power cycle, trouble reset, and system error clear but still trouble code c0204 exist, any idea?

[Brad6784]

Hi guys I've got a Trouble Code C0204 on konica minolta bh c250i, I tried check for paper jammed, and debris, but nothing, tried power cycle, trouble reset, and system error clear but still trouble code c0204 exist, any idea?

Hi, this is an error to do with the tray lifting motor, it’s usually paper trapped behind the paper tray, causing the tray not to rise. Obviously it could be caused by the motor or sensor but I would start by removing the tray and checking for paper. I believe that code is tray 2 but I would check behind all trays, if there is no paper I would then remove the complete pickup unit and investigate further. Good luck!

[tsbservice]

Lol... system error clear for one piece of paper trapped

[Esron Thomas]

Hi, this is an error to do with the tray lifting motor, it’s usually paper trapped behind the paper tray, causing the tray not to rise. Obviously it could be caused by the motor or sensor but I would start by removing the tray and checking for paper. I believe that code is tray 2 but I would check behind all trays, if there is no paper I would then remove the complete pickup unit and investigate further. Good luck!

I've tried that, remove all the trays check but no paper stuck inside the sensor and the pick up unit looks perfectly fine, but the trouble code still exist

[Esron Thomas]

Lol... system error clear for one piece of paper trapped

I physically checked but no piece of paper before doing system error clear..

[Synthohol]

image.png
likely an actuator stuck?
#14
image.png

[Esron Thomas]

image.png
likely an actuator stuck?

Thank you I'll try that out and keep you updated

[copyman]

I would have tried the sys error clear as well if no paper stuck. Did you test sensors for tray 2 in service mode?

[Esron Thomas]

I would have tried the sys error clear as well if no paper stuck. Did you test sensors for tray 2 in service mode?

No I didn't because did remote assistance with the customer via WhatsApp video call and I just told to check and clean the sensor (PS22) I guess?

[JasonSBE]

Did you hit continue, confirm that you wanted to disable the cassette, turn the sub power off then on, then reboot the mfp?

[JMS]

Sounds simple, but have you open and closed the frontdoor without turning machine off and on? Rank B is reset by that.