MP 7500 DF problem

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • mikadonovan
    Senior Tech

    Site Contributor
    2,500+ Posts
    • May 2008
    • 2935
    #1

    MP 7500 DF problem

    I've got a MP 7500 (B246) that has an intermittent df malfunction. Every now and then an original will not feed completely out of the exit rollers. There's about 2 inches of the original still under the rollers. The machine does not show a misfeed. I have cleaned the sensors a few times, but the problem returns. I've reseated the adf main board connectors, no help. Anyone seen this before?
    NEVER ASSUME ANYTHING
    Tags: 223, 500, 750, 7500, adf, b246, before, connectors, every, exit, feed, help, inches, intermittent, main, main board, malfunction, misfeed, nec, original, problem, returns, rollers, sea, sensors, show
    • Fearless V K
      Senior Tech

      500+ Posts
      • May 2007
      • 620
      #2
      I've seen it. It was the connector to the exit motor not fully seated when it happened to me.
      Don't take that toner with me!

        Comment

        • mikadonovan
          Senior Tech

          Site Contributor
          2,500+ Posts
          • May 2008
          • 2935
          #3
          That was EXACTLY what the problem was. Thanks Fearless. You saved me a lot of time on an already busy day.
          Originally posted by Fearless V K
          I've seen it. It was the connector to the exit motor not fully seated when it happened to me.
          NEVER ASSUME ANYTHING

            Comment

            Previous template Next
            Working...