Hi Guys,
on Bizhub C250i bypass not working, we swapped with other, but error is the same. Any idea?
on Bizhub C250i bypass not working, we swapped with other, but error is the same. Any idea?
-
-
If you can provide the error code, someone might be able to help.A Ricoh Service Tech for 7 year. A Konica Minolta Service Tech for 7 years. Now, KM service manager for 4 years.
My Ricoh knowledge is slowly dwindling away at this point. Many things have been lost to time... -
turn the bypass back on in unit isolation?We know a thing or two because we've seen a thing or two.
The medication helps though...Comment
-
I was going to mention that, but it was too obvious biggrin.pngTip for the day; Treat every problem as your dog would.....If you cant eat it or f*ck it....then p*ss on it & walk away...Comment
-
"Not working ... " is a bit too general for me to start hazarding guesses. Can you be a tiny bit more specific?If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
I'm sure with 100+ posts on this forum it was an oversight not providing more info. Can only help with more info. We aren't mind readers or detectives
Comment
-
look on page 57. the one-way gear it mentions is on the same shaft as the feed roller. be careful there is a pin in shaft that the feed slides on to it falls out very easily. the first time you do this I recommend pulling the bypass off to do thisComment
-
Hi All,
i am sorry, forgot to give you a error code. It is C-0211, i tried already to isolate and on again. No luck, as i install another bypass and problem is the same thinking is something with the machine.Comment
-
Worked in IT for 12 years from Helpdesk up to System Administrator. Now working as the IT Manager at a copier company for the last 4 years.
If I helped you out, please give me a thumbs up! It helps my reputation.Comment
-
Just a theory, but on the 8 series copiers, The C-0211 codes on the Bypass unit were caused by 1 way gears in the Paper Feed Drive assy slipping. The C250i series has a paper feed drive assy too, so maybe try one of those.Comment
-
Since you tried another Manual feed unit I would look at the paper feed drive assembly (see attached bulletin)Comment
-
There was a bulletin released about the bypass one way gears being installed backwards from factory. Has this machines bypass ever worked or been tested before?Comment
-
Hi All, we get this machine used and bypass was not working when we tested. We dont have service history from the previous owner.Comment
Comment